Removing and installing front mudguard front section
- Release fasteners (3).
- Release fasteners (1).
- Remove front section of front mudguard.
- Remove bushes (4).
- Installation is the reverse of the removal procedure: pay particular attention to the following.
- Install securing screws (3).
- Tighten securing screws (1).
- Align the two sections of the front mudguard and tighten securing screws (3).
Tightening torques:
- Front mudguard, front, to fork slider bridge (1) M 6 — 4 Nm
- Front mudguard, front and rear sections, to fork slider bridge (3) M 6 — 6 Nm
Removing and installing front mudguard rear section
- Release the fastener (2).
- Remove the rear section of the front mudguard.
- Installation is the reverse of the removal procedure.
Tightening torque:
- Mudguard rear section to fork slider bridge (2) M 6 (clean thread + Loctite 243) — 3 Nm