Removing windscreen cover
- Slightly raise the windscreen.
- From the inside (arrow), unclip windscreen cover (2) from its mount (3).
Removing windscreen
- Remove 4 fasteners (1) (micro-encapsulated).
- Remove windscreen and retaining plates (4).
- Installation is the reverse of the removal procedure: pay particular attention to the following.
Note: It may be necessary to bend the inner mount (3) slightly to ensure that the windscreen cover (2) holds correctly.
Tightening torques:
- Windscreen to windscreen adjuster (clean thread + new screws or Loctite 243) — 2 Nm
Removing and installing windscreen adjuster
- Remove upper section of fairing.
Caution: Do not separate the electric drive for the windscreen adjuster from its holder.
- Open the cable ties (arrows).
- Disconnect plug (3).
- Remove plug (3) and relay (4) from fairing bracket.
- Remove 2 fasteners (1) securing interior trim to windscreen adjuster.
- Remove 5 fasteners (2, 5) securing windscreen adjuster to fairing bracket.
- Remove windscreen adjuster.
- Installation is the reverse of the removal procedure.
Tightening torques:
- Side fasteners (2) securing windscreen adjuster to fairing bracket — 9 Nm
- Centre fastener (5) securing windscreen adjuster to fairing bracket — 3 Nm