Check the rubbers for wear or damage.
Replace them if necessary.
Install a new O-rings to the front and rear insulator grooves.
Install the front insulator to the cylinder head and tighten the bolts securely.
Install the rear insulator to the intake manifold.
Do not tighten the insulator band screw yet.
Install the intake manifold to the front insulator securely.
Install the intake manifold/rear insulator to the cylinder head and align the bolt holes.
Install and tighten the rear insulator bolts securely.
Tighten the insulator band so the insulator band distance is 9 mm (0.4 in).
Install and tighten the bolts securely.
Connect the intake duct control solenoid valve hose to the intake manifold.
Connect the 2P black connector to the front injector.
Connect the 2P gray connector to the rear injector.
Install the throttle body (see below).
Install the injector 2P connectors to their original position.