Lubricate the points listed below with indicated lubricant.
Note. Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high-pressure water spray, perform the general lubrication.
Pivots: Lubricate with Grease.
- Brake Lever
- Brake Pedal
- Clutch Lever
- Rear Brake Joint Pin
- Sidestand
Points: Lubricate with Grease.
- Clutch Inner Cable Upper and Lower Ends [A]
- Throttle Inner Cable Upper and Lower Ends
![](https://motoinstruction.ru/img/kawasaki/13/118605.jpg)
Cables: Lubricate with Rust Inhibitor.
- Clutch Cable
- Throttle Cables
Lubricate the cables by seeping the oil between the cable and housing.
The cable may be lubricated by using a commercially available pressure cable lubricator with an aerosol cable lubricant.
![](https://motoinstruction.ru/img/kawasaki/13/118606.jpg)
With the cable disconnected at both ends, the inner cable should move freely [A] within the cable housing.
★ If cable movement is not free after lubricating, if the cable is frayed [B], or if the cable housing is kinked [C], replace the cable.
![](https://motoinstruction.ru/img/kawasaki/13/118607.jpg)