Specifications
Type | FTZ5L-BS |
Capacity | 12 V, 16.2 kC (4.5 Ah) /10HR |
![](https://motoinstruction.ru/img/suzuki/4/112991.jpg)
Filling with electrolyte
Remove the aluminum tape (1), which covers the battery filler holes (2).
![](https://motoinstruction.ru/img/suzuki/4/112992.jpg)
Remove covers (3) from the electrolyte container.
![](https://motoinstruction.ru/img/suzuki/4/112993.jpg)
Note.
- Do not damage or puncture sealed containers (4) container with electrolyte.
- After the battery is completely filled with electrolyte, use the caps from the electrolyte container to close the battery filling holes (3).
Insert container spouts (5) with electrolyte into the battery filling holes. Hold the electrolyte container firmly so that it does not fall. Do not spill electrolyte!
![](https://motoinstruction.ru/img/suzuki/4/112994.jpg)
Make sure that air bubbles rise in each tank of the container and leave the container in this position for 20 minutes or more.
![](https://motoinstruction.ru/img/suzuki/4/112995.jpg)
Note.
- If air bubbles do not rise in one of the container's tanks, try tapping it lightly at the base.
- Never remove the container from the battery if there is still electrolyte in the container.
Once the container is completely empty, remove it from the battery and wait approximately 20 minutes.
![](https://motoinstruction.ru/img/suzuki/4/112996.jpg)
Insert the lids firmly (1) into the filling holes so that the caps do not protrude above the top surface of the battery protective pad.
![](https://motoinstruction.ru/img/suzuki/4/112997.jpg)
Warning!
- Never use non-compliant batteries.
- Do not remove the covers after they have been installed in the battery.
- Do not insert covers using a hammer.
![]() | ![]() |
Measure the battery voltage using a multi-tester. The tester should show more than 12.5-12.6 V as shown in the figure. If the battery voltage is lower than this, charge the battery using a charger. (See section on battery charging).
![](https://motoinstruction.ru/img/suzuki/4/113000.jpg)
Warning! Do not remove the battery filler caps while charging.
Note. If more than two years have passed since the new battery was manufactured, an initial charging procedure is recommended.
Service
Visually inspect the surface of the battery. If any signs of damage or electrolyte leakage are visible, replace the battery with a new one. If the battery poles are found to be covered with rust or a powdery white oxide substance, clean the battery poles with sandpaper.
Charging operation
Measure the battery voltage using a multi-tester. If the voltage value is less than 12.0 V, charge the battery using a battery charger.
![](https://motoinstruction.ru/img/suzuki/4/113001.jpg)
Warning!
- When charging the battery, remove the battery from the motorcycle.
- Do not remove the battery filler caps while charging.
Charging time: 5-10 hours at a current of 0.5 A or half an hour at 5 A.
![](https://motoinstruction.ru/img/suzuki/4/113002.jpg)
Warning! Never allow the charging current to exceed 5A.
After charging, wait at least 30 minutes and then measure the battery voltage using a multi-tester. If the battery voltage is less than 12.5 V, charge the battery again. If the battery voltage is still less than 12.5 V after recharging, replace the battery with a new one. When a battery is not used for a long time, its state of charge constantly changes. When the motorcycle is not used for more than one month (especially during the winter season), Monitor the battery voltage at least once a month.