Connector/coupler
When connecting a connector, be sure to push it in until a click is felt.
With a lock type coupler, be sure to release the lock when disconnecting, and push it in fully till the works when connecting it.
When disconnecting the coupler, be sure to hold the coupler body and do not pull the lead wires.
Inspect each terminal on the connector/coupler for looseness or bending.
![](https://motoinstruction.ru/img/suzuki/14/120227.jpg)
Inspect each terminal for corrosion and contamination.
The terminals must be clean and free of any foreign material which could impede proper terminal contact.
![](https://motoinstruction.ru/img/suzuki/14/120228.jpg)
Inspect each lead wire circuit for poor connection by shaking it by hand lightly. If any abnormal condition is found, repair or replace.
![](https://motoinstruction.ru/img/suzuki/14/120229.jpg)
When taking measurements at electrical connectors using a tester probe, be sure to insert the probe from the wire harness side (backside) of the connector/coupler.
![](https://motoinstruction.ru/img/suzuki/14/120230.jpg)
(1) Coupler; (2) Probe
When connecting meter probe from the terminal side of the coupler (connection from harness side not being possible), use extra care not to force and cause the male terminal to bend or the female terminal to open.
Connect the probe as shown to avoid opening of female terminal.
Never push in the probe where male terminal is supposed to fit.
Check the male connector for bend and female connector for excessive opening. Also check the coupler for locking (looseness), corrosion, dust, etc.
![](https://motoinstruction.ru/img/suzuki/14/120231.jpg)
(1) Coupler; (2) Probe; (3) Where male terminal fits.
Fuse
When a fuse blows, always investigate the cause correct it and then replace the fuse.
Do not use a fuse of a different capacity.
Do not use wire or any other substitute for the fuse.
![](https://motoinstruction.ru/img/suzuki/14/120232.jpg)
Ecm/various sensors
Since each component is a high-precision part, great care should be taken not to apply any sharp impacts during removal and installation.
![](https://motoinstruction.ru/img/suzuki/14/120233.jpg)
Be careful not to touch the electrical terminals of the ECM. The static electricity from your body may damage this part.
![](https://motoinstruction.ru/img/suzuki/14/120234.jpg)
When disconnecting and connecting the ECM, make sure to turn OFF the ignition switch (1), or electronic parts may get damaged.
![](https://motoinstruction.ru/img/suzuki/14/120235.jpg)
Battery connection in reverse polarity is strictly prohibited. Such a wrong connection will damage the components of the Fl system instantly when reverse power is applied.
![](https://motoinstruction.ru/img/suzuki/14/120236.jpg)
Removing any battery terminal of a running engine is strictly prohibited.
The moment such removal is made, damaging counter electromotive force will be applied to the ECM which may result in serious damage.
![](https://motoinstruction.ru/img/suzuki/14/120237.jpg)
Before measuring voltage at each terminal, check to make sure that battery voltage is 11 V or higher. Terminal voltage check at low battery voltage will lead to erroneous diagnosis.
![](https://motoinstruction.ru/img/suzuki/14/120238.jpg)
Never connect any tester (voltmeter, ohmmeter, or whatever) to the ECM when its coupler is disconnected.
Otherwise, damage to ECM may result.
Never connect an ohmmeter to the ECM with its coupler connected. If attempted, damage to ECM or sensors may result.
Be sure to use a specified voltmeter/ohmmeter. Otherwise, accurate measurements may not be obtained and personal injury may result.