Removal
Warning! Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it from falling and causing injury to the operator or damage to the motorcycle.
1. Undo the fixings securing the mudguard shrouds to the fork legs.
1. Mudguard shroud; 2. Mudguard shroud fixings; 3. Fork leg
2. Detach both shrouds.
3. Detach the brake hoses from their clips on each side of the mudguard.
1. Brake hoses; 2. Clips
4. Release the mudguard fixings and detach the mudguard.
1. Mudguard fixings; 2. Mudguard
Mudguard embellisher removal
Note: To remove the embellisher from the mudguard, it is necessary to remove the triangular Triumph sticker. The sticker will then typically require replacement.
1. Remove the star-washers from each side of the embellisher, inside the mudguard.
1. Embellisher; 2. Star washers
2. Peel back the triangular Triumph sticker to reveal the screw head beneath it.
1. Sticker; 2. Screw head
3. Release the screw to allow detachment of the embellisher.
Embellisher assembly
Caution! When fitting the mudguard embellisher, it is necessary to pull the two ends apart slightly, to avoid damage to the mudguard painted surfaces.
1. Position the embellisher to the mudguard, then fit and tighten the screw to 3 Nm.
2. Working inside the mudguard, fit star washers to each side of the embellisher.
3. Thoroughly clean the area beneath the Triumph sticker.
4. Peel the backing from a new sticker then fix it to the space on the embellisher.
Installation
1. Manoeuvre the mudguard into position between the forks.
2. Fit and tighten the mudguard fixings to 27 Nm.
3. Position the mudguard shrouds to the forks.
4. Fit and tighten the shroud fixings to 9 Nm.
5. Refit the brake hoses to the clips on each side of the mudguard.