Removal
Warning! Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it from falling and causing injury to the operator or damage to the motorcycle.
1. Remove the seat as described on page 17.9.
2. Raise the tool kit.
3. Release the two screws securing each side cover to the frame.
1, Screws; 2. Side covers
Note: During removal of the right hand side cover, disengage the seat lock from the rear of the cover.
4. Raise each side cover until clear of the mounting posts. The covers may then be removed from the motorcycle.
Installation
1. Ensure that the mounting post grommets are correctly installed in the cover bases.
2. Install the covers to their mounting posts ensuring the grommets are not displaced. Ensure that the right hand cover engages correctly over the seat lock.
3. Fit and tighten the cover screws to 9 Nm.
4. Pivot the tool kit into place.
5. Refit the seat as described on page 17.9.