2. Position the rubber air deflector and its retaining plate to the upper mountings as noted for removal.
3. Fit the upper mounting fixings and tighten to 6 Nm.
4. Fit and tighten the lower mounting fixing to 6 Nm.
5. Reconnect the top and bottom hoses. Ensure the hose clips are positioned as noted for removal and secure with the hose clips.
![](https://motoinstruction.ru/img/triumph/15/121572.jpg)
1. Hose clips; 2. Top hose; 3. Bottom hose
6. Secure the clutch cable retaining clip to the top of the radiator.
7. Connect the bypass hose to the radiator and secure with a new hose clip.
![](https://motoinstruction.ru/img/triumph/15/121573.jpg)
1. Hose clip; 2. Bypass hose; 3. Retaining clip; 4. Clutch cable
8. Route the harness for the cooling fan as noted for removal (ensure connectors are pushed through the air deflector) and connect to the main harness.
Note: If fitted, remove the blue identification tape from the horn wire. Do not allow any slack between lower and upper clipping features
9. Fit the horn to the radiator and tighten its fixing to 15 Nm.
![](https://motoinstruction.ru/img/triumph/15/121574.jpg)
1. Fixing; 2. Horn
10. Without allowing any slack between lower and upper clipping features, route the horn wire around the edge of the fan cowl and secure it into the clipping features.
![](https://motoinstruction.ru/img/triumph/15/121575.jpg)
1. Horn wire; 2. Header pipe; 3. Clipping feature
11. Connect the horn's two electrical connectors.
12. Ensure the horn wire does not touch the radiator and that there is no slack between the horn connectors and the lower clipping feature of the fan cowl.
Perform the following operations: