Removing and installing angled lever (BMW F650GS)

0

Slacken the nut of the fastener securing the strut to the angled lever (3).



Slightly raise the rear wheel and withdraw fastener (3).

Remove the fastener securing the angled lever to spring strut (2).

Remove the fastener securing the angled lever to frame (1) and remove the angled lever.

Installation is the reverse of the removal procedure: pay particular attention to the following.

Note: Grease needle bearings with Shell Retinax EP2.

Tightening torques:

• Angled lever to frame: 50 Nm
• Angled lever to spring strut: 47 Nm
• Angled lever to strut: 71 Nm

See this article in russian language

Article about repair motorcycles «BMW F-series F 650 GS» (2000-2007): «Removing and installing angled lever»: https://motoinstruction.ru/en/BMW/F/F650GS/chassis/rsusp/112665 <a href="https://motoinstruction.ru/en/BMW/F/F650GS/chassis/rsusp/112665">Removing and installing angled lever</a> - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Rear suspension». [url=https://motoinstruction.ru/en/BMW/F/F650GS/chassis/rsusp/112665]Removing and installing angled lever[/url] - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Rear suspension».