Removing and installing rear ABS sensor (BMW K1200LT)
- Main
- BMW
- K-series
- K 1200 LT
- Running gear and frame
- Brake system
- Removing and installing rear A…
Caution: Disconnect ground lead from battery and insulate.
- Clean ABS sensor (1) and bore before removing and installing.
- Remove screws securing ABS sensor (1) from brake calliper.
- Remove ABS sensor (1) with spacing plate (2).
- Open cable ties securing ABS sensor cable (3).
- Disconnect plug (arrow).
- Installation is the reverse of the removal procedure: pay particular attention to the following.
Cauton: Carefully route the ABS cable and secure in position with cable ties.
- Check/adjust ABS sensor gap.
- ABS sensor gap — 0.45...0.55 mm (0.018...0.022 in)
Tightening torque:
- ABS sensor mount — 4 Nm
See this article in russian language
This article has been reviewed: Matvey Prokhorov
Similar articles about motorcycles of other brands
Removing the rear wheel sensor and sensor rotor (FZ1-SA),… Yamaha FZ1 Fazer (2006-2015)Removing and installing the rear wheel Honda VTX 1800 C (2001-2008)
Rear Wheel Unit Sensor Battery Alert Triumph Tiger 800 (2010-2019)
Removing the rear brake cylinder support and rear brake… Ducati ST2 (1997-2003)
Rear Wheel Speed Sensor Routing Diagram Suzuki 1000A/XA V-Strom (2014-2019)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Weekly checks
- Maintenance
- Engine and systems
- Engine repair
- Starting and charging system
- Fuel and exhaust systems
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and fork
- Rear wheel drive
- Handlebar
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices