- Remove right side section of fairing.
Caution: Disconnect ground lead from battery and insulate.
- Remove the left brake calliper.
![](https://motoinstruction.ru/img/bmw/21/127437.jpg)
- Open cable ties securing ABS sensor cable (2).
- Release ABS sensor cable (2) from clips (3) on telescopic fork.
- Disconnect plug (1).
Note: Clean ABS sensor and bore before removing/install-ing.
![](https://motoinstruction.ru/img/bmw/21/127438.jpg)
- Release the fasteners (arrows) for ABS sensor (5).
- Take off ABS sensor (5) with spacing plate (4).
- Installation is the reverse of the removal procedure: pay particular attention to the following.
Caution: Carefully route the ABS cable and secure in position with cable ties.
- Check/adjust ABS sensor gap.
- Sensor gap — 0.45...0.55 mm (0.018...0.022 in)
Tightening torque:
- ABS sensor fasteners — 4 Nm