Removing rear wheel
Caution! Do not operate the brake pedal when the brake caliper is removed.
Remove brake caliper.
Note: Carefully bend the rear wheel cover to the right to permit wheel removal, but do not remove the cover. Screws are secured with Loctite.
Remove wheel studs with taper rings.
Remove the rear wheel.
Installing rear wheel
Caution! Contact faces on rear wheel drive and hub must be clean and free of grease.
Hold rear wheel in position at rear wheel drive and high-tighten the wheel studs with taper rings.
Caution!
- Use only wheel studs with length code 63.
- Do not oil or grease wheel studs!
Tighten the wheel studs.
Install brake caliper.
[ABS] Check sensor gap and adjust if necessary.
ABS sensor gap — 0.45...0.55 mm (0.018...0.022 in)
Tightening torque:
Screw in wheel studs handtight, then tighten in diagonally opposite sequence
- Initial tightening — 72 Nm
- Final tightening — 105 Nm