Do not tighten the lower holder nuts yet.
Apply grease to the throttle grip flange groove.
Connect the throttle cables to the throttle grip flange and install the throttle grip onto the handlebar.
Place the handlebar onto the lower holders and align the punch mark on the handlebar with the top of the lower holder.
Install the upper holder.
Install the upper holder bolts and tighten the forward bolts first, then tighten the rear bolts to the specified torque.
Torque: 26 N·m (2.7 kgf·m, 20 lbf·ft).
Install the bolt caps securely.
Tighten the lower holder nuts to the specified torque.
Torque: 64 N·m (6.5 kgf·m, 47 lbf·ft).
Install the right handlebar switch housing onto the handlebar, aligning the locating pin with the hole in the handlebar.
Install the attaching screws and tighten the forward screw first, then tighten the rear screw.
Install the master cylinder and holder with the "UP" mark facing up.
Align the end of the master cylinder with the punch mark on the handlebar and tighten the upper bolt first, then tighten the lower bolt.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft).
Connect the front brake switch connectors.
Install the left handlebar switch housing end.
Clean the inside surface of the left handlebar grip and the outside surface of the left handlebar.
Apply Honda Bond A or Honda Grip Cement (U.S.A, only) to the inside surface of the left handlebar grip and to the outside surface of the left handlebar.
Wait 3-5 minutes and install the grip.
Rotate the grip for even application of the adhesive.
Install the left handlebar grip end cap.
Allow the adhesive to dry for 1 hour before using.
Install the left handlebar switch housing onto the handlebar, aligning the locating pin with the hole in the handlebar.
Install the attaching screws and tighten the forward screw first, then tighten the rear screw.
Install the clutch master cylinder and holder with the "UP" mark facing up.
Align the end of the clutch master cylinder with the punch mark on the handlebar and tighten the upper bolt first, then tighten the lower bolt.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft).
Connect the clutch switch connectors.
