Remove the fork cap from the outer pipe.
Slide outer pipe down onto the axle holder.
Be careful not to scratch the outer pipe or damage the dust seal.
Pull down the rubber stopper.
Hold the rod lock nut with a spanner, then loosen and remove the fork cap from the rod.
Remove the rubber stopper from the rod.
Pull down the outer pipe so the inner fork bolt is visible.
Remove the inner fork bolt.
Tool: Lock nut wrench, 36 x 44 mm 07VMA-MZ0010A.
Remove the rebound rod assembly.
Remove the spring collar, fork spring joint plate and fork spring.
Pour out the fork fluid by pumping the fork pipe up and down several times.
Remove the dust seal.
Remove the stopper ring.
Do not scratch outer pipe sliding surface.
Pull the fork slider out until from the slider bushing is felt. Then remove it in and out, tapping the bushing lightly until the fork slider separates from the outer pipe. The slider bushing will be forced out by the fork pipe bushing.
Carefully remove the slider bushing by prying the slot with a screwdriver until the bushing can be pulled off by hand.
Remove the guide bushing, back-up ring, oil seal, stopper ring and dust seal from the fork slider.