EVAP purge control valve (California type only) (Honda VTX1800C)

0

Removal

Disconnect the EVAP purge control valve 2P black connector.

Disconnect the air hoses from the EVAP purge control valve.

Remove the bolt and EVAP purge control valve bracket assembly.

Installation is in the reverse order of removal.

Inspection

Remove the EVAP purge control valve.

Check that the air should not flow from (A) to (B), only when the 12-V battery is connected to the EVAP purge control valve terminals.



Check the resistance between the terminals of the EVAP purge control valve.

Standard: 30-34 Ω (20°C/68°F).

If the resistance is out of specification, replace the EVAP purge control valve.

See this article in russian language

Article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008): «EVAP purge control valve (California type only)»: https://motoinstruction.ru/en/Honda/VTX/1800C/engine/fuel/112331 <a href="https://motoinstruction.ru/en/Honda/VTX/1800C/engine/fuel/112331">EVAP purge control valve (California type only)</a> - article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008) from section «Fuel and control system». [url=https://motoinstruction.ru/en/Honda/VTX/1800C/engine/fuel/112331]EVAP purge control valve (California type only)[/url] - article about repair motorcycles «Honda VTX series VTX 1800 C» (2001-2008) from section «Fuel and control system».