Removal
Notice:
- Handle the O2 sensor with care.
- Do not get grease, oil or other materials in the O2 sensor air hole.
Do not service the O2 sensor while it is hot.
Remove the seat (page 2-2).
Disconnect the O2 sensor 4P connector.
Remove the O2 sensor unit.
Notice:
- Be careful not to damage the sensor wire.
- Do not use an impact wrench while removing or installing the O2 sensor.
Install the O2 sensor unit.
Tighten the unit to the specified torque.
Torque: 25 N·m (2.6 kgf·m, 19 lbf·ft).
Route the O2 sensor wire into the frame.
Connect the O2 sensor 4P connector.
Install the seat (page 2-2).
