- For models equipped with an ABS, remove the rear fender front (See Rear Fender Front Removal in the Frame chapter).
- Inspect the brake hoses, fittings and pipes (ABS equipped models) for deterioration, cracks and signs of leakage.
- The high pressure inside the brake line can cause fluid to leak [A] or the hose, pipes (ABS equipped models) to burst if the line is not properly maintained. Bend and twist the rubber hose while examining it.
- Replace the hose and pipe (ABS equipped models) if any crack [B], bulge [C] or leakage is noticed.
- Tighten any brake hose banjo bolts and brake pipe joint nuts.
- Torque-Brake Hose Banjo Bolts: 25 №m (2.5 kgf·m, 18 ft·lb)
- Brake Pipe Joint Nuts: 18 N·m (1.8 kgf·m, 13 ft·lb) (KLE650B Models)
- Inspect the brake hose routing.
If any brake hose and pipe (ABS equipped models) routing is incorrect, route the brake hose according to Cable, Wire, and Hose Routing section in the Appendix chapter.