MotoInstruction.ru
Mobile
version
Articles
& news
Site
map
Feed
back
Add to
bookmark
English Русский
Aprilia
BMW
Ducati
Harley
Honda
Kawasaki
Suzuki
Triumph
Yamaha
Triumph:
Rocket▾
Rocket III (2004-2018)
Street Triple▾
765 R/RS [4] (2017-2024)
Tiger▾
Tiger 800 (2010-2019)

Inlet air temperature sensor — pinpoint tests (Triumph Rocket III)

  • Main
  • Triumph
  • Rocket
  • Rocket III
  • Engine and systems
  • Fuel and control system
  • Inlet air temperature sensor —…
0
Contents: Pinpoint tests ↓ Circuit diagram ↓
Fault CodePossible causeAction
P0113Open circuit, or short circuit to battery+View & note diagnostic tool "freeze frame" data if available.
View & note diagnostic tool "sensor" data.
Ensure sensor connector is secure. Disconnect ECM and proceed to pinpoint test 1
P0112Short circuit to groundDisconnect sensor and proceed to pinpoint test 6

Pinpoint tests



TestResultAction
1 Check cable and terminal integrity:
- ECM pin A22
- ECM pin A07
OKProceed to test 2
FaultyRectify fault, proceed to test 7
2 Check resistance value:
- ECM pin A22 to ECM pin A07 (Temperature dependent-see below)
OKDisconnect temp sensor and proceed to test 6
Open circuitDisconnect temp sensor and proceed to test 3
Short circuitDisconnect temp sensor and proceed to test 4
3 Check cable continuity:
- ECM pin A22 to sensor pin 1
- ECM pin A07 to sensor pin 2
OKProceed to test 5
Open circuitLocate and rectify wiring fault, proceed to test 7
4 Check cable for short circuit:
- ECM pin A22 to ECM pin A07
OKProceed to test 5
Short circuitLocate and rectify wiring fault, proceed to test 7
5 Check sensor resistance:
- Sensor pin 1 to sensor pin 2 (Temperature dependent-see below)
OKProceed to test 7
FaultyRenew temp sensor, proceed to test 7
6 Check cable for short circuit:
- ECM pin A22 to ground
OKProceed to test 7
Short circuitLocate and rectify wiring fault, proceed to test 7
7 Reconnect harness, clear fault code and run engine to verify fault clearedOKAction complete - quit test
FaultContact Triumph service

Circuit diagram



If engine is warm, remove sensor and allow time to cool to ambient prior to test.


Resistance data:

Ambient tempResistance value
80°C200 to 400Ω
20°C2.35 to 2.65KΩ
-10°C8.50 to 10.25KΩ

Inlet air temperature sensor — pinpoint tests
See this article in russian language
This article has been reviewed: Serafim Sazonov
◀ Previous
Triumph Rocket III : Fuel and control system
Next ▶

Coolant temperature sensor — pinpoint tests
Ignition coils — pinpoint tests
Purge valve — pinpoint tests
Throttle position sensor — pinpoint tests
Fuel pump relay — pinpoint tests
System voltage — pinpoint tests
Cooling fan relay — pinpoint tests
Tachometer — pinpoint tests
Similar articles about motorcycles of other brands
Inlet air temperature sensor (service code 13) Kawasaki Vulcan VN 900 (2006-2024)
Engine coolant temperature sensor — removal, installation… Suzuki V-Strom DL-1000K2/K9 (2002-2012)
Checking the coolant temperature sensor Yamaha FZ1 Fazer (2006-2015)
Coolant Temperature Sensor — Removal and Installation Honda CB 400 SF (1992-1999)
Intake air temperature sensor: IAT — removal and… Harley-Davidson V-Rod (2002-2006)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
 


Add up two numbers: 25 + 41

       



 

 
Rocket III (2004-2018) 
  • Information for owner
  • Introduction to manual
  • Engine and systems
  • Engine repair
  • Cooling system
  • Lube system
  • Fuel and control system
  • Transmission
  • Running gear and frame
  • Frame and hinged elements
  • Front suspension and handlebar
  • Rear suspension
  • Brake system
  • Wheels and tires
  • Electric equipment
  • Equipment and devices
  • Starting and charging system
  • Electrical circuits
Aprilia BMW Ducati Harley Honda Kawasaki Suzuki Triumph Yamaha
MotoInstruction.ru © 2021–2026 | Sitemap | Articles | Contacts | | Add to bookmarks | Mobile version