Coolant temperature sensor — pinpoint tests (Triumph Rocket III)
- Main
- Triumph
- Rocket
- Rocket III
- Engine and systems
- Fuel and control system
- Coolant temperature sensor — p…
Contents: Pinpoint tests ↓ Circuit diagram ↓
| Fault Code | Possible cause | Action |
| P0118 | Open circuit, or short circuit to battery+ | View & note diagnostic tool "freeze frame" data if available. View & note diagnostic tool "sensor" data. Ensure sensor connector is secure. Disconnect ECM and proceed to pinpoint test 1 |
| P0117 | Short circuit to ground | Disconnect sensor and proceed to test 6 |
Pinpoint tests
| Test | Result | Action |
| 1 Check cable and terminal integrity: - ECM pin A09 - ECM pin A07 | OK | Proceed to test 2 |
| Faulty | Rectify fault, proceed to test 7 | |
| 2 Check resistance value: - ECM pin A09 to ECM pin A07 (Temperature dependent,-see below) | OK | Disconnect temp sensor and proceed to test 6 |
| Open circuit | Disconnect sensor and proceed to test 3 | |
| Short circuit | Disconnect temp sensor and proceed to test 4 | |
| 3 Check cable continuity: - ECM pin A09 to sensor pin 1 - ECM pin A07 to sensor pin 2 | OK | Proceed to test 5 |
| Open circuit | Locate and rectify wiring fault, proceed to test 7 | |
| 4 Check cable for short circuit: - ECM pin A09 to ECM pin A07 | OK | Proceed to test 5 |
| Short circuit | Locate and rectify wiring fault, proceed to test 7 | |
| 5 Check sensor resistance: - Sensor pin 1 to sensor pin 2 (Temperature dependent,-see below) | OK | Proceed to test 7 |
| Faulty | Renew temp sensor, proceed to test 7 | |
| 6 Check cable for short circuit: - ECM pin A09 to ground | OK | Proceed to test 7 |
| Short circuit | Locate and rectify wiring fault, proceed to test 7 | |
| 7 Reconnect harness, clear fault code and run engine to verify fault cleared | OK | Action complete - quit test |
| Fault | Contact Triumph service |
Circuit diagram
Resistance data under typical conditions:
- Warm engine: 200 to 400Ω
- Cold engine:
- 20°C ambient — 2.35 to 2.65KΩ
- -10°C ambient — 8.50 to 10.25KΩ
(Information copied from the resource MOTOINSTRUCTION)

See this article in russian language
This article has been reviewed: Serafim Sazonov
Similar articles about motorcycles of other brands
Engine coolant temperature sensor — removal, installation… Suzuki V-Strom DL-1000K2/K9 (2002-2012)Checking the coolant temperature sensor Yamaha FZ1 Fazer (2006-2015)
Coolant Temperature Sensor — Removal and Installation Honda CB 400 SF (1992-1999)
Engine coolant temperature sensor: ECT — removal and… Harley-Davidson V-Rod (2002-2006)
Removing and installing coolant-temperature sensor БМВ F 650 GS (2000-2007)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Engine and systems
- Engine repair
- Cooling system
- Lube system
- Fuel and control system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Starting and charging system
- Electrical circuits
