Removing the stanchion tubes — sliders (Aprilia RS125/3)

0

Read 1.2.1 carefully.

Torque wrench settings:

• Top yoke bolt (1): 25 Nm (2.5 kg·m)
• Bottom yoke bolts (2): 25 Nm (2.5 kg·m)

Note. The operations described below apply to both fork legs.

Warning! Service the fork legs one at a time. Always refit a fork leg in the correct position before removing the other.

Perform the first seven steps of the procedure described at paragraph 7.9.2.

Remove the front wheel; see 7.5.2.

Place the slider in a vice with soft jaws.

Warning! The stanchion-and-slider assembly contains oil. Do not turn it over or tilt it during removal.

Slacken the bolt (1).



Slacken the two bolts (2).



Slide stanchion and slider off the top and bottom yokes.

See this article in russian language

Removal engine components without removing the engine from… Suzuki DRZ 250 (1996-2007)
Removing the camshafts Yamaha FZ1 Fazer (2006-2015)
Removing and installing water pump Kawasaki Versys 650 (2007-2025)
Front Brake Disc — Checking, Removing and Installing Honda CB 400 SF (1992-1999)
Removing the instrument panel side covers Ducati ST2 (1997-2003)

Article about repair motorcycles «Aprilia RS-series RS 125» (1998-2005): «Removing the stanchion tubes — sliders»: https://motoinstruction.ru/en/Aprilia/RS/RS125-3/chassis/fsusp/112891 <a href="https://motoinstruction.ru/en/Aprilia/RS/RS125-3/chassis/fsusp/112891">Removing the stanchion tubes — sliders</a> - article about repair motorcycles «Aprilia RS-series RS 125» (1998-2005) from section «Front suspension and handlebar». [url=https://motoinstruction.ru/en/Aprilia/RS/RS125-3/chassis/fsusp/112891]Removing the stanchion tubes — sliders[/url] - article about repair motorcycles «Aprilia RS-series RS 125» (1998-2005) from section «Front suspension and handlebar».