Removing and installing footbrake lever (BMW F650GS)

0

Remove footrest plate (1).



Disengage piston thrust rod (4).

Remove hexagon fit bolt (2).

Remove brake pedal (3), leaving torsion spring (5) on the frame.

Installation is the reverse of the removal procedure: pay particular attention to the following.

Note:

• Grease the bearing bushing with Staburags NBU 30 PTM.
• Check play at piston thrust rod and adjust if necessary.
• See removal and installation of brake master cylinder.

Caution! Check operation of brake-light switch (6).

Play at piston thrust rod: 0.5...1.5 mm (0.02...0.06 in).

Tightening torque:

• Brake pedal to frame: 21 Nm

See this article in russian language

Article about repair motorcycles «BMW F-series F 650 GS» (2000-2007): «Removing and installing footbrake lever»: https://motoinstruction.ru/en/BMW/F/F650GS/chassis/brake/112678 <a href="https://motoinstruction.ru/en/BMW/F/F650GS/chassis/brake/112678">Removing and installing footbrake lever</a> - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Brake system». [url=https://motoinstruction.ru/en/BMW/F/F650GS/chassis/brake/112678]Removing and installing footbrake lever[/url] - article about repair motorcycles «BMW F-series F 650 GS» (2000-2007) from section «Brake system».