Removing and installing flap for tank cap
- Remove tank cover.
- Remove locking pints (1) on left and right.
- Remove studs (2) on left and right.
- Remove flap for tank cap.
- Installation is the reverse of the removal procedure.
Removing and installing snap lock for tank cap flap
- Open flap for tank cap.
Note: Note position of snap lock in tank cover.
- Using cranked long-nosed pliers, compress side springs (arrows) and lift out snap lock.
- Installation is the reverse of the removal procedure.
Removing and installing fuel tank lock barrel
- Remove fuel cap.
- Slightly straighten the 4 lugs in the underside of the grip one after the other and remove the barrel from the grip
- Remove lock barrel (3) together with housing (4).
- Insert key and turn to OPEN position.
- Use a length of wire or similar to press in the locking pin.
- Use the ignition key to remove lock barrel (3) from housing (4).
- Grease lock barrel (3) with Retinax EP 2.
- Insert locking pin (6) groove upward into housing (2), together with spring (5).
- Introduce lock barrel (3) into housing (4), stub (arrow) must engage groove in locking pin (6).
- From this point on, installation is the reverse of the removal procedure.