Removing and installing seat (BMW K1200LT)

0

Removing and installing front seat with bridge

• Remove left and right fairing side sections.
• Remove tank cover.
• [Seat heating]. Disconnect plug for seat heating.
• Remove 5 screws (arrows) and remove seat and bridge.
• Installation is the reverse of the removal procedure: pay particular attention to the following.
• Note rubber washer (1) and grommet (2).

Tightening torques:

• Bridge, seat to frame M 6 — 9 Nm
• Bridge, seat to frame M 8 — 21 Nm

Removing and installing rear seat

• Lift the seat at the front.
• Remove 2 screws and remove seat.
• [Seat heating]. Disconnect plug for seat heating.
• Installation is the reverse of the removal procedure.

Tightening torques:

• Seat to rear frame — 9 Nm

Removing and installing rear seat backrest

• Open the top case.
• Remove 4 screws and remove backrest.
• Installation is the reverse of the removal procedure.

Tightening torques:

• Seat backrest to top case — 5 Nm

See this article in russian language

Article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009): «Removing and installing seat»: https://motoinstruction.ru/en/BMW/K/K1200LT/chassis/frame/115896 <a href="https://motoinstruction.ru/en/BMW/K/K1200LT/chassis/frame/115896">Removing and installing seat</a> - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Frame and hinged elements». [url=https://motoinstruction.ru/en/BMW/K/K1200LT/chassis/frame/115896]Removing and installing seat[/url] - article about repair motorcycles «BMW K-series K 1200 LT» (1998-2009) from section «Frame and hinged elements».