- headlight and headlight case (page 19-5)
- handlebar (page 13-3)
- turn signal assembly (page 19-5)
- front wheel (page 13-8)
Remove the bolts and front brake pipe clamps from the steering stem.
![](https://motoinstruction.ru/img/honda/9/116315.jpg)
Remove the bolt and front brake hose clamp from the top bridge.
![](https://motoinstruction.ru/img/honda/9/116316.jpg)
Remove the bolts and headlight stay from the steering stem.
![](https://motoinstruction.ru/img/honda/9/116317.jpg)
Loosen the steering stem nut.
Remove the fork legs (page 13-14), then remove the steering stem nut and washer.
Remove the top bridge.
![](https://motoinstruction.ru/img/honda/9/116318.jpg)
Straighten the lock washer tabs, and remove top adjusting nut В and the lock washer.
![](https://motoinstruction.ru/img/honda/9/116319.jpg)
Loosen top adjusting nut A, hold the steering stem and remove top adjusting nut A using the special tool.
Tool: Steering stem socket 07916-3710100.
![](https://motoinstruction.ru/img/honda/9/116320.jpg)
Remove the upper bearing and steering stem/lower bearing.
Check the steering bearings and races for wear or damage.
![](https://motoinstruction.ru/img/honda/9/116321.jpg)
Always replace the bearings and races as a set.
Bearing replacement
Drive out the upper bearing outer race using the special tool.
Tools:
- Driver 07949-3710001
- Attachment, 37x40 mm 07746-0010200
![](https://motoinstruction.ru/img/honda/9/116322.jpg)
Drive out the lower bearing outer race using the special tool.
Tools:
- Bearing race remover 07946-3710500
- Driver 07949-3710001
- Attachment, 37x40 mm 07746-0010200
![](https://motoinstruction.ru/img/honda/9/116323.jpg)
Temporarily install the steering stem nut to prevent the threads from being damaged when removing the lower bearing inner race from the stem.
Remove the lower bearing and dust seal with a chisel or equivalent tool, being careful not to damage the stem.
![](https://motoinstruction.ru/img/honda/9/116324.jpg)
Apply grease to new dust seal lips and install it over the steering stem.
Install a new lower bearing using the special tool and a hydraulic press.
Tool:
- Steering stem driver 07946-MB00000
- Pilot, 35 mm 07746-0040800
![](https://motoinstruction.ru/img/honda/9/116325.jpg)