Note.
- Check bushings and washers manually for binding. If any problems are found, replace them.
- Before installing the gears, apply engine oil to the inside surfaces of the gears and bushings
- Before installing the seals, apply lubricant to them.
Attention!
- Never reuse spring rings. After removing such a ring from the shaft, it should be thrown away and a new one installed in its place.
- When installing a new ring, be careful not to spread the ends further than necessary to fit onto the shaft.
- After installing the ring, make sure it is completely seated in the groove and firmly in place.
Note. When assembling the transmission, pay attention to the location and positioning of all washers and circlips. Refer to the cross section for proper installation of gears, washers and circlips.
When installing a new snap ring, pay attention to its orientation. Press it against the wall of the groove in the direction of the axial force acting during operation. The rounded edge should face the gear.
Attention! When installing the first gear bushing, align the oil hole (2) bushings with corresponding hole (1) on the shaft.
![]() | ![]() |
![](https://motoinstruction.ru/img/suzuki/4/112589.jpg)