Each headlight bulb can be replaced as follows:
Warning! The bulb becomes hot during use. Always allow sufficient time for the bulb to cool before handling. Avoid touching the glass part of the bulb. If the glass is touched or gets dirty, clean with alcohol before re-use.
Warning! Do not reconnect the battery until the assembly process has been completed. Premature battery reconnection could result in ignition of the battery gases causing risk of injury.
1. Unscrew the headlight bulb cover from the rear of the headlight assembly and remove with the gasket.
1. Headlight assembly; 2. Headlight bulb cover
2. Disconnect the multi-pin electrical connector from the headlight bulb.
1. Headlight assembly; 2. Headlight bulb; 3. Multi-pin connector
3. Detach the wire retainer from its clip (do not remove the screw) then remove the bulb from the light unit.
1. Wire retainer; 2. Screw; 3. Headlight bulb
4. Installation is the reverse of the removal procedure noting the following:
Daytime Running Lights (DRLs) and LED Position Lights
This model is fitted with either daytime running lights (DRL) or LED position lights. The DRL or LED position light are situated within the headlight assembly and are sealed, maintenance free LED units. The headlight unit must be replaced in the event of the failure of the DRLs or LED position lights.