Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
An additional rubber band has been added to the ignition switch harness on models from the VIN numbers shown in the tables below, it is also retrofittable to earlier models. Therefore when refitting or replacing an ignition switch follow the instruction described below.
All Markets except Brazil and India
Street Triple S | From VIN AG7300 |
Street Triple R and Street Triple RS | From VIN AF5453 |
Brazil and India Markets Only
All Street Triple Models | From VIN AF7304 |
When refitting an original ignition switch on models up to the VIN numbers shown above, the rubber band is not required therefore follow the routing for reassembly as noted during removal.
The riding modes allow the rider to adjust the throttle response (MAP), Anti-lock Brake System (ABS) and Traction Control (TC) settings to suit differing road conditions and rider preference.
Before disconnecting the battery or removing a fuse, note and record the rider's settings. Once the fuse has been refitted or the battery reconnected the rider's settings should be reset as noted.
Warning! If the battery has been disconnected or the fuses removed for any reason advise the rider to confirm the original mode settings have been correctly set. Failure to reset the motorcycle to the rider's preferred rider mode settings and subsequently being ridden may cause loss of motorcycle control and an accident.
1. Disconnect the electrical connector from the fir tree clip and frame.
2. Disconnect the ignition switch harness from the main harness.
![](https://motoinstruction.ru/img/triumph/15/121961.jpg)
1. Ignition switch harness connector; 2. Main harness connector
3. Noting its orientation, route the ignition switch harness connector through the right hand side of the frame.
4. Remove the cable guide and discard the fixings.
![](https://motoinstruction.ru/img/triumph/15/121962.jpg)
1. Fixings; 2. Cable/harness guide; 3. Ignition switch harness; 4. Frame
5. Remove the upper yoke (see Upper yoke - removal).
6. Using a suitable drill and stud extractor, extract the shear bolts from the ignition switch.
![](https://motoinstruction.ru/img/triumph/15/121963.jpg)
1. Sheared bolts; 2. Ignition switch
7. Remove the ignition switch from the upper yoke.