Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
An additional rubber band has been added to the ignition switch harness on models from the VIN numbers shown in the tables below, it is also retrofittable to earlier models. Therefore when refitting or replacing an ignition switch follow the instruction described below.
All Markets except Brazil and India
Street Triple S | From VIN AG7300 |
Street Triple R and Street Triple RS | From VIN AF5453 |
Brazil and India Markets Only
All Street Triple Models | From VIN AF7304 |
When refitting an original ignition switch on models up to the VIN numbers shown above, the rubber band is not required therefore follow the routing for reassembly as noted during removal.
1. Fit the ignition switch to the upper yoke.
2. Fit new shear bolts and tighten to 16 Nm.
3. Discard the sheared bolt head.
![](https://motoinstruction.ru/img/triumph/15/121964.jpg)
1. Shear bolts; 2. Ignition switch
Note: Fit the wire guide making sure the cables and the harnesses are routed as shown.
4. Refit the upper yoke (see Upper yoke - installation).
5. Connect the ignition switch harness connector to the main harness connector.
6. Reconnect the electrical connector to the fir tree clip and frame.
![](https://motoinstruction.ru/img/triumph/15/121965.jpg)
1. Ignition switch harness connector; 2. Main harness connector
7. Fit the wire guide making sure the cables and the harnesses are routed as shown below. Secure with new lock nuts and tighten to 20 Nm.
![](https://motoinstruction.ru/img/triumph/15/121966.jpg)
1. Cable guide; 2. Brake switch harness; 3. Right hand switch housing harness; 4. Throttle position sensor harness; 5. Brake hose; 6. Clutch cable
Note:
- The 66 mm rubber band secures the brake hose, brake switch, twist grip position sensor and right hand switch housing wires. The band is located adjacent to the top yoke pinch bolt when the handlebars are in the straight ahead position.
- The 88 mm rubber band secures the brake hose, brake switch, twist grip position sensor, right hand switch housing wires, clutch cable and ignition switch harness. The top edge of the band is located 30-40 mm below the wire guide.
8. Position the 66 mm rubber band around the brake hose, brake switch, twist grip position sensor and RH switch housing wires as shown below.
9. Loop the ignition switch harness in the orientation shown below.
10. Collect the brake hose, clutch cable, brake switch, twist grip position sensor, right hand switch housing wires and ignition switch harness, and secure with the 88 mm rubber band (supplied in the kit) so that the band is positioned between 30 and 40 mm below the wire guide.
![](https://motoinstruction.ru/img/triumph/15/121967.jpg)
1. Ignition switch; 2. Ignition switch harness; 3. Cable tie; 4. Rubber band 88 mm (supplied in kit); 5. Rubber band 66 mm (original fitment); 6. Cable guide
11. Route the harnesses around the head stock as shown below.
12. Fit the cable/harness guide and tighten the new fixings to 13 Nm.
![](https://motoinstruction.ru/img/triumph/15/121968.jpg)
1. Ignition switch; 2. Ignition switch harness; 3. Brake switch harness; 4. Right hand switch housing harness; 5. Throttle position sensor harness; 6. Brake hose; 7. Clutch cable; 8. Fixings; 9. Cable/harness guide