Prepare
1. Remove wheel. See Front wheel or Rear wheel.
2. Check wheel bearings. See Sealed wheel bearings.
Inspect
PART NUMBER | TOOL NAME |
HD-99500-80 | WHEEL TRUING AND BALANCING STAND |
Wheel Stand
1. Mount wheel in a WHEEL TRUING AND BALANCING STAND (Part No. HD-99500-80).
- a. Install the truing arbor in the wheel hub so that the hub spins freely on its bearings.
2. Mount a gauge rod or a dial indicator to the base of the truing stand.
Lateral Runout
1. Check lateral wheel runout.
- a. See Figure 3-14. Point the gauge rod or indicator at the rim bead flange.
- b. Rotate the wheel and measure the lateral distance at several locations.
- c. Compare readings to specifications. Refer to Table 3-4.
- d. Replace as necessary.
Radial Runout
1. Check radial wheel runout.
- a. See Figure 3-15. Point the gauge rod or indicator at the rim tire bead safety hump.
- b. Rotate the wheel and measure the lateral distance at several locations.
- c. Replace as necessary.
![](https://motoinstruction.ru/img/harley/22/127697.jpg)
Figure 3-14. Lateral Runout
![](https://motoinstruction.ru/img/harley/22/127698.jpg)
Figure 3-15. Radial Runout
Complete
1. Install wheel. See Front wheel or Rear wheel.