Fan on sensor — removal and installation (Honda CB400SF)

0

Before removing the sensor, it is necessary to drain the coolant from the system (see «Coolant - replacement»).

Removing

1. Disconnect the connector from the fan on sensor.



2. Using a 24 mm spanner, unscrew the sensor.



3. Remove the sensor and check the integrity of the rubber o-ring. If necessary, replace the ring.

Installation

Install the fan switch in reverse order. The sensor must be tightened with a torque of 9 Nm.

See this article in russian language

Article about repair motorcycles «Honda CB series CB400SF» (1992-1999): «Fan on sensor — removal and installation»: https://motoinstruction.ru/en/Honda/CB/CB400SF-1/engine/cooling/110255 <a href="https://motoinstruction.ru/en/Honda/CB/CB400SF-1/engine/cooling/110255">Fan on sensor — removal and installation</a> - article about repair motorcycles «Honda CB series CB400SF» (1992-1999) from section «Cooling system». [url=https://motoinstruction.ru/en/Honda/CB/CB400SF-1/engine/cooling/110255]Fan on sensor — removal and installation[/url] - article about repair motorcycles «Honda CB series CB400SF» (1992-1999) from section «Cooling system».