Removal
Drain the clutch hydraulic system (page 10-4).
Remove the clutch hose oil bolt, sealing washers and clutch hose.
![](https://motoinstruction.ru/img/honda/9/115966.jpg)
When removing the oil bolt, cover the end of the hose to prevent contamination.
Remove the bolts and clutch slave cylinder assembly.
![](https://motoinstruction.ru/img/honda/9/115967.jpg)
Remove the gasket and dowel pins.
![](https://motoinstruction.ru/img/honda/9/115968.jpg)
Disassembly
Remove the slave cylinder piston and spring.
If the piston is hard to remove, do the following: Place a shop towel over the piston to cushion the piston when it is expelled, and position the cylinder with the piston down.
Apply small squirts of air pressure into the fluid inlet to remove the pistons.
![](https://motoinstruction.ru/img/honda/9/115969.jpg)
Do not use high pressure air or bring the nozzle too close to the inlet.
Inspection
Check the piston spring for fatigue or damage.
Inspect the oil and piston seals for damage or deterioration.
Replace the oil seal and piston seal if necessary. Clean the seal grooves with clean brake fluid.
Check the slave cylinder for scoring or other damage. Check the slave cylinder piston for scratches, scoring or other damage.
![](https://motoinstruction.ru/img/honda/9/115970.jpg)
Assembly
Install the new piston seal with its groove side facing the slave cylinder.
Install the new oil seal with its groove side facing the slave cylinder piston.
Lubricate the piston and piston seal with brake fluid.
Install the spring and piston into the slave cylinder.
![](https://motoinstruction.ru/img/honda/9/115971.jpg)
Installation
Install the dowel pins and new gasket.
Apply silicone grease to the tip of the push rod.
Install the slave cylinder onto the left crankcase cover.
![](https://motoinstruction.ru/img/honda/9/115972.jpg)
Install and tighten the bolts securely.
![](https://motoinstruction.ru/img/honda/9/115973.jpg)
Connect the clutch hose to the master cylinder with the clutch hose oil bolt and new sealing washers.
While pushing the clutch hose against the stopper, tighten the clutch hose oil bolt to the specified torque.
Torque: 34 N·m (3.5 kgf·m, 25 lbf·ft).
Fill the reservoir to the upper level and bleed the hydraulic system (page 10-4).
![](https://motoinstruction.ru/img/honda/9/115974.jpg)