![](https://motoinstruction.ru/img/suzuki/4/112710.jpg)
Install the fuel jet, aligning the slot (A) with guide (IN).
![](https://motoinstruction.ru/img/suzuki/4/112711.jpg)
Install the idle fuel jet (1) and needle valve seat (2).
![](https://motoinstruction.ru/img/suzuki/4/112712.jpg)
Attention! Use a new rubber ring.
Install the quality screw.
![](https://motoinstruction.ru/img/suzuki/4/112713.jpg)
3. Rubber ring; 4. Washer; 5. spring; 6. Quality screw
Tighten the quality screw until it stops, and then unscrew it the required number of turns.
Install the base (7) and main fuel jet (8).
![](https://motoinstruction.ru/img/suzuki/4/112714.jpg)
Reinstall the float mechanism.
![](https://motoinstruction.ru/img/suzuki/4/112715.jpg)
Install the accelerator pump mechanism ((9) -piston, (10) – spring and (11) – rod).
![](https://motoinstruction.ru/img/suzuki/4/112716.jpg)
Attention! Install the accelerator pump piston with the small protrusion towards the spring.
Install the float chamber cover.
![](https://motoinstruction.ru/img/suzuki/4/112717.jpg)
Install the throttle valve.
Install the throttle mechanism and gasket.
![](https://motoinstruction.ru/img/suzuki/4/112718.jpg)
Attention!
- Replace the gasket with a new one.
- Install the gasket between the carburetor body and the throttle valve.
Hook the spring onto the fasteners (A) And (IN).
Install the drive (1).
![](https://motoinstruction.ru/img/suzuki/4/112719.jpg)
Attention! Make sure the drive rotates without jamming.
Install the throttle valve drive mechanism.
Tighten the bolt (2) normalized moment.
![](https://motoinstruction.ru/img/suzuki/4/112720.jpg)
Throttle Lever Bolt (2): 3.5 Nm (0.35 kgf-m).
Install the damper travel stop screw.
![](https://motoinstruction.ru/img/suzuki/4/112721.jpg)
Install the choke button.
![](https://motoinstruction.ru/img/suzuki/4/112722.jpg)
Install the top cover (1).
![](https://motoinstruction.ru/img/suzuki/4/112723.jpg)
Attention! Use a new gasket to prevent fuel leakage.
Install the throttle cable mounting bracket.
![](https://motoinstruction.ru/img/suzuki/4/112724.jpg)
Mounting clamps
Orient the clamps as shown in the picture.
![]() (from the air filter side) | ![]() (from the engine side) |
After installing the carburetor, adjust the following items to specification:
- Throttle cable free play - section 2-12
- Idle speed - section 2-13