Remove left and right covers. See above.
Note: Note washers and rubber ring.
Remove windscreen (1).
Remove the fasteners securing the cockpit fairing (2).
Disconnect multi-pin plug (5).
Pull the rubber boot to the rear.
Pull the socket of the sidelight out of the headlight housing.
Remove the fairing lower section complete with headlight (8).
Remove instrument cover (3).
Remove fairing upper section (4).
Remove front mudguard. See below.
Disconnect plug for horn (7).
Remove cover (6).
Installation is the reverse of the removal procedure: pay particular attention to the following.
Warning! After installing the windscreen, check and if necessary adjust the headlight setting.
Tightening torques:
- Windscreen fasteners: 2 Nm