Aligning left-hand rubber mount
Caution: The alignment of the left-hand rubber mounts relative to the frame is preset at the factory.
- Do not slacken the paint-marked Torx screws (1) unless the rubber mount has to be replaced.
- Prepare a template as shown in the illustration above.
- Insert template (2) between left/right bearing mounts and press against machined face (arrow) on right.
- Slide left bearing bushing into its mount.
- Lightly press bearing bushing against template and uniformly tighten screws (1).
Aligning right-hand rubber mount
Caution: It is not necessary to re-align the right-hand rubber mount unless the gearbox, the frame or the lefthand rubber mount has been replaced.
- Install the right-hand bearing bushing, but do not tighten the securing screws.
- Position gearbox against intermediate flange and tighten securing screws.
- Lower the frame.
- Tighten the left/right engine mountings on the cross-member.
- Install and tighten bolt securing gearbox to frame.
Caution: To avoid damaging the spacing plate in the clamp slot, uniformly tighten the left and right pinch bolts.
- Uniformly tighten the pinch bolts (3) securing the right-hand rubber mount.
Tightening torques:
- Pinch bolts for rubber mounts — 9 Nm