Caution! Always install bearing by applying pressure to outer race.
Removing and installing front spring strut
Tightening torque:
- Spring strut to frame — 43 Nm
- Spring strut to leading link — 50 Nm
Disassembling and assembling leading link (BMW R1150GS)
Press the bearing out/in with a suitable tool.
Tightening torque:
Tightening torque:
See this article in russian language
Removing and installing leading link
Measuring telescopic fork
Disassembling and assembling telescopic fork
Checking friction at ball joint/angular-contact ball bearing
Removing and installing slider tube bridge
Removing and installing fork bridge
Removing and installing telescopic fork without fork bridge
Front suspension specifications
Measuring telescopic fork
Disassembling and assembling telescopic fork
Checking friction at ball joint/angular-contact ball bearing
Removing and installing slider tube bridge
Removing and installing fork bridge
Removing and installing telescopic fork without fork bridge
Front suspension specifications
Removing and installing left handlebar fitting
Removing and installing right handlebar fitting
Removing and installing brake piston in handlebar fitting
Removing and installing clutch piston in handlebar fitting
Checking and adjusting operating clearance at front brake/clutch levers
Removing and installing handlebar
Removing and installing Bowden-cable divider
Disassembling Bowden-cable divider
Removing and installing right handlebar fitting
Removing and installing brake piston in handlebar fitting
Removing and installing clutch piston in handlebar fitting
Checking and adjusting operating clearance at front brake/clutch levers
Removing and installing handlebar
Removing and installing Bowden-cable divider
Disassembling Bowden-cable divider
Similar articles about motorcycles of other brands
Yamaha FZ1 Fazer (2006-2015): Disassembling the starter motor
Triumph Street Triple 765 (2017-2024): Drag link frame bearings — removal
Suzuki DRZ 250 (1996-2007): Disassembling the carburetor (E-03, E-28)
Ducati ST2 (1997-2003): Disassembling fuel tank components
Aprilia RS 125/3 (1998-2005): Disassembling the stanchion tubes — sliders
Link to this article in different formats
TEXTHTMLBB Code
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Maintenance
- Engine and systems
- Engine repair
- Fuel and exhaust systems
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear wheel drive
- Wheels and tires
- Brake system
- Electric equipment
- Equipment and devices
- Starting and charging system