![](https://motoinstruction.ru/img/ducati/18/124535.jpg)
![](https://motoinstruction.ru/img/ducati/18/124536.jpg)
Insert the shaft (16) in stop plate (23) and washer (24) and secure with circlip (9).
![](https://motoinstruction.ru/img/ducati/18/124537.jpg)
![](https://motoinstruction.ru/img/ducati/18/124538.jpg)
Ensure that the shaft with lever (16) is positioned correctly relative to stop plate (23). The edges of the plate must be equidistant from the pin of the lever; to adjust the position, loosen the locknut (13) and turn eccentric pin (15).
![](https://motoinstruction.ru/img/ducati/18/124539.jpg)
![](https://motoinstruction.ru/img/ducati/18/124540.jpg)
Position the spring (10) between the shaft (16) and the fork (14).
Fit the ring (12) to secure the assembly.
Check that the spring (10) is installed correctly as shown in the figure.
Tighten the nut (13) to the specified torque (Engine torque settings).
![](https://motoinstruction.ru/img/ducati/18/124541.jpg)
![](https://motoinstruction.ru/img/ducati/18/124542.jpg)
![](https://motoinstruction.ru/img/ducati/18/124543.jpg)