Disassembly engine block fittings (Ducati ST2)

0

Unscrew the pressure adjustment valve closing screw (A) and remove the spring and the pin.



Unscrew the pin screw and remove the seal, the spring and the gearshift cap.



Unscrew the screw (B) on the right side crankcase half and remove the ratchet, the washer and the spring.



Unscrew and remove the gearbox idle position switch and its washer.

See this article in russian language

Article about repair motorcycles «Ducati ST series ST2» (1997-2003): «Disassembly engine block fittings»: https://motoinstruction.ru/en/Ducati/ST/ST2/engine/repair/112128 <a href="https://motoinstruction.ru/en/Ducati/ST/ST2/engine/repair/112128">Disassembly engine block fittings</a> - article about repair motorcycles «Ducati ST series ST2» (1997-2003) from section «Engine repair». [url=https://motoinstruction.ru/en/Ducati/ST/ST2/engine/repair/112128]Disassembly engine block fittings[/url] - article about repair motorcycles «Ducati ST series ST2» (1997-2003) from section «Engine repair».