Disconnect and connect
Disconnect
1. Pull back the secondary lock.
2. Press the locking latch.
3. Pull the connector from the sensor.
Connect
1. Align the connector housings.
2. Press the housings together until the latch snaps into place.
3. Snap in the secondary lock.
Remove terminal
| PART NUMBER | TOOL NAME |
| GA500A | SNAP-ON TERMINAL PICK |
1. See Figure A-1. Slide the locking bar off the terminal housing.
2. Insert the smallest pins of the SNAP-ON TERMINAL PICK (Part No. GA500A) into the gaps on each side of the socket to compress the tangs on each side of the terminal.
3. Gently pull on the wire to remove the terminal.
Install terminal
1. See Figure A-2. Bend the tangs on each side of the terminal outward.
2. Align terminal to the housing.
3. Install the terminal into housing. Terminal will snap into place.
Note: The teeth of the locking bar face down.
4. Install the locking bar onto the connector.
Figure A-1. Terminal Removal: Bosch Compact 1.1M Connector
Figure A-2. Tangs: Bosch Compact 1.1 M Socket Terminal