Disconnect and connect
Disconnect
1. See Figure A-3. Lift the external locking latch.
2. Pull the connector housings apart.
Connect
1. Align the connector housings.
2. Press the housings together until external latch(es) engage.
Remove terminal
1. Connectors with wire lock: See Figure A-4. Remove the wires from wire lock.
- a. Pry loose one side of wire lock (1) from socket housing.
- b. Pry loose the other side, if necessary.
- c. Remove the wires from wire lock.
2. Remove terminal lock (2) from housing.
Note: Terminal will be difficult to remove if the tang is not released.
3. Pry tang (3) away from terminal. Pull on wire to back terminal out of chamber.
Install terminal
1. Push in tang on housing.
2. Push terminal into the cavity of the connector housing.
3. Gently pull wire to verify that terminal is secure.
4. Install colored terminal lock into housing.
5. Connectors with wire lock: Install wires in wire lock.
- a. Seat wires in separate channels of wire lock.
- b. Push channels inside chambers at wire end of housing until lock fully engages housing.
![](https://motoinstruction.ru/img/harley/22/127942.jpg)
Figure A-3. Delphi GT 150 Sealed Connector: Socket Housing Latch
![](https://motoinstruction.ru/img/harley/22/127943.jpg)
Figure A-4. Delphi GT 150 Sealed Connector: Removing Socket Terminals: 1. Remove wire lock; 2. Remove terminal lock; 3. Pry tang outward