Crankcase right hand cover — installation (Triumph Street Triple 765 R/RS)
- Main
- Triumph
- Street Triple
- 765 R/RS [4]
- Engine and systems
- Engine repair
- Crankcase right hand cover — i…
Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
1. Fit a new gasket to the crankcase right hand cover.
2. Fit the crankcase right hand cover and tighten its fixings to 10 Nm in the sequence shown below.
3. Re-tighten the fixings one and two to 10 Nm.
Crankcase right hand cover fixings tightening sequence
The original text is available on an online resource MotoInstruction.ru
See this article in russian language
This article has been reviewed: Kirill Prokofiev
Similar articles about motorcycles of other brands
Left crankcase rear cover — removal and installation Honda VTX 1800 C (2001-2008)Starter right-hand end cover assembly — inspection Kawasaki ZX6R/ZX600J (2000-2002)
Disassembly of the alternator-side crankcase cover Ducati Monster 696 (2007-2014)
Clutch — right crankcase cover Yamaha Drag Star 1100 (1998-2008)
Cylinder head cover — disassembly and assembly Suzuki V-Strom DL-650 (2004-2011)
Link to this article in different formats
Comments and feedback from visitors
No comments yet, you will be the first!
- Information for owner
- Introduction to manual
- Engine and systems
- Engine repair
- Fuel and control system
- Lubrication system
- Cooling system
- Transmission
- Running gear and frame
- Frame and hinged elements
- Front suspension and handlebar
- Rear suspension
- Brake system
- Wheels and tires
- Electric equipment
- Equipment and devices
- Starting and charging system
- Electrical circuits