Lower Fairing Removal
- Remove the mounting bolts [A] and lower fairing [B].
![](https://motoinstruction.ru/img/kawasaki/23/129042.jpg)
Lower Fairing Installation
Tighten:
Torque - Lower Fairing Mounting Bolts: 8.8 Nm (0.90 kgf·m 78 in·lb)
Middle Fairing Removal
Remove:
- Windshield (See Windshield Removal)
- Bolts [A]
- Pull the middle fairing [B] evenly outward to clear the stopper [C].
![](https://motoinstruction.ru/img/kawasaki/23/129043.jpg)
Middle Fairing Installation
- Insert the projection [A] into the grommet [B] on the fuel tank.
![](https://motoinstruction.ru/img/kawasaki/23/129044.jpg)
- Fit the slots [A] into the rib [B] of the inner cover [C].
![](https://motoinstruction.ru/img/kawasaki/23/129045.jpg)
- Tighten the middle fairing mounting bolts as shown sequence [1-6] in the figure
![](https://motoinstruction.ru/img/kawasaki/23/129046.jpg)
Middle Fairing Bracket Removal
Remove:
- Middle Fairings (See Middle Fairing Removal)
- Windshield Brackets (See Windshield Bracket Removal) Inner Cover (See Inner Cover Removal)
- Headlight Assy (see Headlight Removal in the Electrical System chapter)
- Meter Unit (See Meter Unit Removal in the Electrical System chapter)
- Turn Signal Relay (See Turn Signal Relay Inspection in the Electrical System chapter)
- Oil Pressure Warning Indicator Light (LED) Delay Unit (See Oil Pressure) Warning Indicator Light (LED) Delay Unit Removal in the Electrical System chapter)
- Coolant Reserve Tank (See Coolant Change in the Periodic Maintenance chapter)
- Bolt [A]
![](https://motoinstruction.ru/img/kawasaki/23/129047.jpg)
- Cut off the bands [A].
- Open the clamp [B].
- Free the main harness from the middle fairing bracket [C].
Remove:
- Mounting Bolts [D] and Nuts
Middle Fairing Bracket
![](https://motoinstruction.ru/img/kawasaki/23/129048.jpg)
Middle Fairing Bracket Installation
- Tighten the mounting bolts and nuts, using the following steps.
Tighten the mounting bolt [A].
Tighten the upper mounting bolt [B] and nut.
Tighten the lower mounting bolt [C] and nut.
- Route the harness and leads correctly (See Cable, Wire, and Hose Routing section in the Appendix chapter).
![](https://motoinstruction.ru/img/kawasaki/23/129049.jpg)
Inner Cover Removal
- Remove the middle fairings (See Middle Fairing Removal).
- Push the central pin, and then remove the quick rivets [A].
Remove:
- Bolts [B]
- Inner Cover [C]
![](https://motoinstruction.ru/img/kawasaki/23/129050.jpg)
Inner Cover Installation
- Installation is the reverse of removal.
lnsert the hook [A] of the inner cover into the slot [B] of the headlight assy.
![](https://motoinstruction.ru/img/kawasaki/23/129051.jpg)