Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
Note: Note the routing of the front ABS wheel speed sensor harness and its retaining clips for installation. The front ABS wheel speed sensor multiplug is identified as the white connector located above the camshaft cover, near the left hand side.
![](https://motoinstruction.ru/img/triumph/15/121768.jpg)
1. Front ABS wheel speed sensor multiplug
1. Disconnect the front ABS wheel speed sensor multiplug.
2. Detach the wheel speed sensor harness from its clips on the front brake hose and the rubber cap on the caliper bleed screw.
3. Release the three fixings and remove the wheel speed sensor harness cover from the left fork leg. Discard the fixings.
![](https://motoinstruction.ru/img/triumph/15/121769.jpg)
1. Wheel speed sensor harness cover; 2. Fixings; 3. Sensor; 4. Sensor harness
4. Release the fixing and remove the sensor. Collect the shim from between the sensor and fork leg.
![](https://motoinstruction.ru/img/triumph/15/121770.jpg)
1. Front ABS wheel speed sensor; 2. Fixing; 3. Sensor harness; 4. Rubber bleed screw cap