Warning!
- Make sure the motorcycle is stabilised and adequately supported.
- A correctly supported motorcycle will help prevent it from falling.
- An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
Perform the following operations:
- Seat - removal
- Battery - removal
- Fuel tank - removal
- Airbox - removal
- Throttle bodies/injectors - removal
- Front sprocket cover - removal
- Coolant expansion tank - removal
- Alternator cover - removal
1. Withdraw the starter idler gear and shaft, noting the fitted position of the components.
![](https://motoinstruction.ru/img/triumph/15/121992.jpg)
1. Idler gear; 2. Idler shaft
Caution! Do not use tools to tighten T3880375 - Alternator Rotor Holder. Tighten the tool by hand only. Over-tightening of the tool will lead to damage to the alternator rotor.
2. To remove the rotor, clean the alternator rotor to remove all traces of oil, and fit T3880375 - Alternator Rotor Holder to the rotor as shown below. Retain the tool to prevent the crankshaft from rotating and remove the centre bolt from the crankshaft.
![](https://motoinstruction.ru/img/triumph/15/121993.jpg)
1. Rotor; 2. T3880375 - Alternator Rotor Holder
3. With the bolt removed, locate the spigot from the larger of the two thrust pads supplied with T3880365 - Alternator Housing Puller to the crankshaft.
![](https://motoinstruction.ru/img/triumph/15/121994.jpg)
1. Thrust pad
Note: Ensure that the thrust pad does not fall out during assembly of the tool.
4. Assemble T3880365 - Alternator Housing Puller to the threaded centre section of the rotor.
5. Hold the centre of T3880365 - Alternator Housing Puller to prevent rotation then tighten the draw-bolt in the centre of the tool to release the taper seating of the rotor from the crankshaft.
![](https://motoinstruction.ru/img/triumph/15/121995.jpg)
1. Rotor; 2. T3880365 - Alternator Housing Puller
6. Withdraw the rotor and tool as an assembly and then separate the tool from the rotor. Collect the Woodruff key and the tool thrust pad from the crankshaft.