1. Release the locking device and slide the bottom of the level sender to the fuel tank opening. Withdraw from the tank and allow any remaining fuel to drain into a suitable container.
1. Fuel level sensor; 2. Locking device
Float replacement
1. Insert a small screwdriver into one of the tabs at the top of the float assembly and gently prise the lid free.
1. Tab; 2. Lid
2. Invert the assembly and allow the float unit to slide free.
3. Discard the old float unit.
4. Insert the new float unit in the orientation shown below ensuring the magnet cover on the face of the unit faces towards the bottom of the support tube.
Note: It is possible to fit the float unit upside down. An incorrect fuel level reading will be indicated during motorcycle operation if the float unit is fitted upside down.
1. Support tube; 2. Float unit; 3. Lid; 4. Magnet cover; 5. Slider
5. Refit the lid ensuring the tabs on the lid locate correctly with the cut-outs in the top of the support tube.