To remove the right-hand footrest, unscrew the screws (A) while counterholding the nut (B) and remove the rear brake fluid reservoir (C).
![](https://motoinstruction.ru/img/ducati/18/124040.jpg)
Before removing the left footrest bracket, unscrew the screw (D) securing the gearchange lever to the engine, but leave the gearchange assembly attached to the bracket.
![](https://motoinstruction.ru/img/ducati/18/124041.jpg)
Unscrew the upper two screws (3) securing the bracket to the swingarm.
Recover the washers (17) located between the bracket and the frame.
Unscrew the lower screws (11) and (18) securing the LH footrest bracket (15) to the crankcase, recovering the two washers (2).
![](https://motoinstruction.ru/img/ducati/18/124042.jpg)
![](https://motoinstruction.ru/img/ducati/18/124043.jpg)
Remove the brake master cylinder (E) by unscrewing the two screws (F): slide the master cylinder (E) off the pushrod (G).
Disconnect the rear brake sensor (H) from the main wiring harness.
![](https://motoinstruction.ru/img/ducati/18/124044.jpg)
Remove the RH footrest bracket assembly (8).
To separate the rear RH footrest (13) from the footrest bracket (8), remove the circlip (5) and drive out the pin (4) to release the footrest (13), the plates (10), the ball (9) and the spring (12).
![](https://motoinstruction.ru/img/ducati/18/124045.jpg)
![](https://motoinstruction.ru/img/ducati/18/124046.jpg)
![](https://motoinstruction.ru/img/ducati/18/124047.jpg)
To separate the front RH footrest (7) from the bracket (8), remove the circlip (5) and drive out the pin (4) to release the footrest (7) and the spring (6).
![](https://motoinstruction.ru/img/ducati/18/124048.jpg)
![](https://motoinstruction.ru/img/ducati/18/124049.jpg)
The procedure is the same for the LH footrest.
Note: The footrest may also be removed with the footrest bracket installed on the motorcycle.