To reassemble the front RH footrest (7), locate the spring (6) between the footrest lugs and attach it to the footrest bracket, inserting the straight end of the spring in the hole in the bracket.
Grease the pin (4) and insert it from the top, securing it on the other side with the circlip (5).
Locate the spring (12), the plates (10), the balla (9) and RH rear footrest (13) between the lugs on the RH footrest bracket (8).
Grease the pin (4) and insert it from the top, securing it on the other side with the circlip (5).
Check the condition of the rubber bushes (1) installed on the footrest bracket.
If they need to be renewed, orientate them as shown in the figure.
Locate them in correspondence with the threaded holes in the frame and the crankcase.
Caution! When refitting the LH footrest bracket (15), position the washers (2) in correspondence with the fixings on the engine crankcase.
Refit the brake master cylinder (E) and tighten the screws (F) to the specified torque (Frame torque settings). Reconnect the rear brake sensor (H) to the main wiring harness.
Insert the rear brake pushrod (G) in the rear brake master cylinder (E).
Fix the footrest brackets (8) and (15) to the swingarm with the screws (3), suitably lubricated, with the washers (17), and to the engine with screws (11) and (18). Tighten the screws (3), (11) and (18) to the specified torque (Frame torque settings) in the sequence indicated.
Fix the gearchange control to the engine crankcase, applying threadlocker to the screw (D) and tightening it to the specified torque (Frame torque settings).
Refit the rear brake reservoir (C), tightening the screw (A) to the specified torque (Frame torque settings).