![](https://motoinstruction.ru/img/ducati/18/124627.jpg)
Install the flywheel-rotor-driven gear assembly on the crankshaft, taking care not to alter the position of the inner race (18) relative to the washer (17).
The flywheel reference mark must be aligned with the groove on the crankshaft, in correspondence with the keyway.
![](https://motoinstruction.ru/img/ducati/18/124628.jpg)
Lubricate the contact surfaces of Belleville washer (33) with engine oil.
Fit the Belleville washer (33) on the end of the crankshaft.
![](https://motoinstruction.ru/img/ducati/18/124629.jpg)
Apply the recommended threadlocker to the threads of the crankshaft and the flywheel nut (34).
![](https://motoinstruction.ru/img/ducati/18/124630.jpg)
Restrain the rotation of the flywheel with the holding tool 88713.2036.
![](https://motoinstruction.ru/img/ducati/18/124631.jpg)
Caution! Tighten the nut (34) to the specified torque (Engine torque settings).
Remove all traces of Loctite from the threads of the nut (34) and the crankshaft (A).
![](https://motoinstruction.ru/img/ducati/18/124632.jpg)
![](https://motoinstruction.ru/img/ducati/18/124633.jpg)