Wiring Inspection
- Visually inspect the wiring for signs of burning, fraying, etc.
If any wiring is poor, replace the damaged wiring.
- Pull each connector [A] apart and inspect it for corrosion, dirt, and damage.
If the connector is corroded or dirty, clean it carefully. If it is damaged, replace it.
- Check the wiring for continuity.
Use the wiring diagram to find the ends of the lead which is suspected of being a problem.
Connect the hand tester between the ends of the leads.
![](https://motoinstruction.ru/img/kawasaki/23/129106.jpg)
Special Tool - Hand Tester: 57001-1394
Set the tester to the x 1 Ω range, and read the tester.
If the tester does not read 0 Ω, the lead is defective. Replace the lead or the wiring harness [B] if necessary.
![](https://motoinstruction.ru/img/kawasaki/23/129107.jpg)