Removal
1. Remove the rider's seat (see page 16-13).
2. Disconnect the battery, negative (black) lead first.
3. Remove the windscreen (see page 16-19).
4. Remove the two fixings and remove the screen upper bracket.
1. Upper screen bracket; 2. Fixings
5. Remove the cover attached to the rear of the instruments.
Note: The cover is held in place by a bayonet type fixing. Gently pull on the cover to release it.
1. Instrument Cover
6. Disconnect the electrical connector from the instruments.
7. Remove the screw and release the instrument pack from the bracket bayonet fixings.
1. Screw; 2. Bayonet fixings; 3. Electrical connector
Installation
1. Position the instrument pack to the bracket.
2. Insert the bayonet fixings into the grommets.
3. Refit the fixing and tighten to 2 Nm.
4. Connect the instruments to the harness.
1. Screw; 2. Bayonet fixings; 3. Electrical connector
5. Install the cover and gasket to the rear of the instruments, ensuring the bayonet fixing is fully inserted in the grommets on the instrument bracket.
6. Refit the screen upper bracket and tighten the two fixings to 3 Nm.
7. Refit the windscreen (see page 16-21).
8. Reconnect the battery, positive (red) lead first.
9. Refit the rider's seat (see page 16-13).